STR9100>STR9100>tftpboot 0x1000000 kernel.bin Check MAC/PHY 0 Link Status : UP! Check MAC/PHY 1 Link Status : DOWN! ARP broadcast 1 eth addr: 00:19:66:35:2b:79 TFTP from server 192.168.1.150 ; our IP address is 192.168.1.151 Filename 'kernel.bin'. Load address: 0x1000000 Loading: ###################################################################################################################################################################################################################################################################################################################################################################################################################################################################################################################################### done Bytes transferred = 2651380 (2874f4 hex) STR9100>go 0x1000000 KDB: debugger backends: ddb KDB: current backend: ddb Copyright (c) 1992-2009 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD is a registered trademark of The FreeBSD Foundation. FreeBSD 9.0-CURRENT #204: Mon Sep 28 22:08:53 UTC 2009 yohanes@connor.lan:/usr/home/yohanes/work/src/sys/arm/compile/CNS11XXNAS Preloaded elf kernel "elf kernel" at 0xc129ec18. unknown CPU (ID = 0x66015261) WB enabled LABT 16KB/16B 2-way Instruction cache 16KB/16B 2-way write-back-locking-B Data cache real memory = 67108864 (64 MB) Physical memory chunk(s): 00000000 - 0xffffff, 16777216 bytes (4096 pages) 0x1303000 - 0x3e9efff, 45727744 bytes (11164 pages) avail memory = 61865984 (59 MB) ULE: setup cpu 0 null: random: nfslock: pseudo-device mem: econaarm0: on motherboard econa_alloc_resource start 00000000 end ffffffff, count = 00000008 econa_alloc_resource start 00000000 end ffffffff, count = 00000008 sys_res_memory �٬�+}�����}ɕͽ�ɍ��start 00000000 end ffffffff, count = 00000008 econa_alloc_resource start 00000000 end ffffffff, count = 00000008 sys_res_memory �uart0: mem 0x78000000-0x78ffffff irq 10 on econaarm0 econa_alloc_resource start 00000000 end ffffffff, count = 00000008 sys_res_memory econa_alloc_resource start 00000000 end ffffffff, count = 00000001 sys_res_irq uart0: [FILTER] uart0: fast interrupt uart0: console (38461,n,8,1) timer0: mem 0x79000000-0x79ffffff irq 0,1 on econaarm0 econa_alloc_resource start 00000000 end ffffffff, count = 00000001 sys_res_memory econa_alloc_resource start 00000000 end ffffffff, count = 00000001 sys_res_irq econa_alloc_resource start 00000000 end ffffffff, count = 00000001 sys_res_irq System clock 00000051Reset conf 00038240STR9100 CPU Clock: 200 MHz IRQ Timer1 at int #0x0 clock 100000000(Hz) timer0: [FILTER] timer0: [FILTER] ohci0: mem 0xf0000000-0xf7ffffff irq 23 on econaarm0 econa_alloc_resource start 00000000 end ffffffff, count = 00000001 sys_res_memory econa_alloc_resource start 00000000 end ffffffff, count = 00000001 sys_res_irq ohci0: [MPSAFE] ohci0: [ITHREAD] usbus0 on ohci0 ehci probe ehci probe ehci0: mem 0xf8000000-0xffffffff irq 24 on econaarm0 econa_alloc_resource start 00000000 end ffffffff, count = 00000001 sys_res_memory econa_alloc_resource start 00000000 end ffffffff, count = 00000001 sys_res_irq ehci0: [MPSAFE] ehci0: [ITHREAD] usbus1: EHCI version 1.0 usbus1: on ehci0 ece0: mem 0xe0000000-0xe0ffffff irq 18,19,20,21,22 on econaarm0 econa_alloc_resource start 00000000 end ffffffff, count = 00000001 sys_res_memory econa_alloc_resource start 00000000 end ffffffff, count = 00000001 sys_res_irq econa_alloc_resource start 00000000 end ffffffff, count = 00000001 sys_res_irq econa_alloc_resource start 00000000 end ffffffff, count = 00000001 sys_res_irq phy0_id=0x243, phy1_id=ffff using IC_PLUS_PHY size of rx = 16 tx = 16 ece0: using rmii: 0 ece0: Generating random ethernet address. ece_attach ../../../arm/econa/if_ece.c:460 ece_attach ../../../arm/econa/if_ece.c:462 miibus0: on ece0 ukphy0: PHY 0 on miibus0 ukphy0: OUI 0x0090c3, model 0x0005, rev. 4 ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto ece_attach ../../../arm/econa/if_ece.c:469 ece_attach ../../../arm/econa/if_ece.c:485 ece_attach ../../../arm/econa/if_ece.c:498 ece0: bpf attached ece0: Ethernet address: 00:aa:bb:cc:dd:19 ece0: [MPSAFE] ece0: [ITHREAD] ece0: [MPSAFE] ece0: [ITHREAD] ece0: [MPSAFE] ece0: [ITHREAD] ece_attach ../../../arm/econa/if_ece.c:531 ece_attach ../../../arm/econa/if_ece.c:535 ece_attach ../../../arm/econa/if_ece.c:541 Timecounter "CPU Timer" frequency 50000000 Hz quality 1000 Timecounters tick every 10.000 msec lo0: bpf attached usbus0: 12Mbps Full Speed USB v1.0 usbus1: 480Mbps High Speed USB v2.0 ugen0.1: at usbus0 uhub0: on usbus0 ugen1.1: at usbus1 uhub1: on usbus1 uhub0: 2 ports with 2 removable, self powered uhub1: 2 ports with 2 removable, self powered ugen1.2: at usbus1 umass0: on usbus1 umass0: SCSI over Bulk-Only; quirks = 0x0000 umass0:0:0:-1: Attached to scbus0 pass0 at umass-sim0 bus 0 scbus0 target 0 lun 0 pass0: Removable Direct Access SCSI-2 device pass0: Serial Number 001CC05FE932F921315D01AE pass0: 40.000MB/s transfers GEOM: new disk da0 da0 at umass-sim0 bus 0 scbus0 target 0 lun 0 da0: Removable Direct Access SCSI-2 device da0: Serial Number 001CC05FE932F921315D01AE da0: 40.000MB/s transfers da0: 1906MB (3903578 512 byte sectors: 255H 63S/T 242C) Trying to mount root from ufs:da0s1a warning: no time-of-day clock registered, system time will not be set accurately start_init: trying /sbin/init No suitable dump device was found. Entropy harvesting: interrupts ethernet point_to_point kickstart. /dev/da0s1a: FILE SYSTEM CLEAN; SKIPPING CHECKS /dev/da0s1a: clean, 798658 free (1146 frags, 99689 blocks, 0.1% fragmentation) Additional TCP/IP options: rfc1323 extensions=NO no-ipv4-mapped-ipv6sysctl: unknown oid 'net.inet6.ip6.v6only' . ifconfig: DHCP: bad value reactivating stuff ece0: link state changed to UP ifconfig: DHCP: bad value Starting Network: lo0 ece0. init lockedDHCPREQUEST on ece0 to 255.255.255.255 port 67 ip length 328 disagrees with bytes received 344. accepting packet with data after udp payload. DHCPNAK from 192.168.1.1 DHCPDISCOVER on ece0 to 255.255.255.255 port 67 interval 4 ip length 328 disagrees with bytes received 344. accepting packet with data after udp payload. ip length 328 disagrees with bytes received 344. accepting packet with data after udp payload. DHCPOFFER from 192.168.1.150 ip length 328 disagrees with bytes received 344. accepting packet with data after udp payload. DHCPOFFER from 192.168.1.1 DHCPREQUEST on ece0 to 255.255.255.255 port 67 ip length 328 disagrees with bytes received 344. accepting packet with data after udp payload. DHCPACK from 192.168.1.150 init lockedbound to 192.168.1.20 -- renewal in 300 seconds. route: writing to routing socket: Address family not supported by protocol family add net ::ffff:0.0.0.0: gateway ::1: Address family not supported by protocol family route: writing to routing socket: Address family not supported by protocol family add net ::0.0.0.0: gateway ::1: Address family not supported by protocol family route: writing to routing socket: Address family not supported by protocol family add net fe80::: gateway ::1: Address family not supported by protocol family route: writing to routing socket: Address family not supported by protocol family add net ff02::: gateway ::1: Address family not supported by protocol family Waiting 30s for the default route interface: ............................. /etc/rc: WARNING: Dump device does not exist. Savecore not run. Thu Sep 24 19:52:47 UTC 2009 FreeBSD/arm (isabelle) (ttyu0) login: root Sep 24 19:53:16 isabelle login: ROOT LOGIN (root) ON ttyu0 Last login: Thu Sep 24 18:45:17 on ttyu0 Copyright (c) 1992-2009 The FreeBSD Project. Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994 The Regents of the University of California. All rights reserved. FreeBSD 9.0-CURRENT (CNS11XXNAS) #204: Mon Sep 28 22:08:53 UTC 2009 Welcome to FreeBSD! Before seeking technical support, please use the following resources: o Security advisories and updated errata information for all releases are at http://www.FreeBSD.org/releases/ - always consult the ERRATA section for your release first as it's updated frequently. o The Handbook and FAQ documents are at http://www.FreeBSD.org/ and, along with the mailing lists, can be searched by going to http://www.FreeBSD.org/search/. If the doc distribution has been installed, they're also available formatted in /usr/share/doc. If you still have a question or problem, please take the output of `uname -a', along with any relevant error messages, and email it as a question to the questions@FreeBSD.org mailing list. If you are unfamiliar with FreeBSD's directory layout, please refer to the hier(7) manual page. If you are not familiar with manual pages, type `man man'. You may also use sysinstall(8) to re-enter the installation and configuration utility. Edit /etc/motd to change this login announcement. isabelle# cat > /etc/resolv.conf search lan nameserver 192.168.1.1 ^Disabelle# route add default 192.168.1.1 add net default: gateway 192.168.1.1 isabelle# ping google.com PING google.com (74.125.45.100): 56 data bytes 64 bytes from 74.125.45.100: icmp_seq=0 ttl=45 time=276.039 ms 64 bytes from 74.125.45.100: icmp_seq=1 ttl=45 time=276.111 ms ^C --- google.com ping statistics --- 2 packets transmitted, 2 packets received, 0.0% packet loss round-trip min/avg/max/stddev = 276.039/276.075/276.111/0.036 ms isabelle# cd /root isabelle# ftp koala Connected to koala.lan. 220 ProFTPD 1.3.2a Server (Debian) [::ffff:192.168.1.150] Name (koala:root): yohanes 331 Password required for yohanes Password: 230 User yohanes logged in Remote system type is UNIX. Using binary mode to transfer files. ftp> !ls .cshrc idwiki-latest-pages-articles.xml.bz2 .k5login iperf-2.0.4 .login iperf-2.0.4.tar.gz .profile usb_dos_bootdisk.img.bz2 .ssh ftp> put usb_dos_bootdisk.img.bz2 b2 local: usb_dos_bootdisk.img.bz2 remote: b2 229 Entering Extended Passive Mode (|||63990|) 150 Opening BINARY mode data connection for b2 100% |*************************************| 7404 KB 1.52 MB/s 00:00 ETA 226 Transfer complete 7582416 bytes sent in 00:04 (1.52 MB/s) ftp> put usb_dos_bootdisk.img.bz2 b2 local: usb_dos_bootdisk.img.bz2 remote: b2 229 Entering Extended Passive Mode (|||32330|) 150 Opening BINARY mode data connection for b2 100% |*************************************| 7404 KB 2.00 MB/s 00:00 ETA 226 Transfer complete 7582416 bytes sent in 00:03 (2.00 MB/s) ftp>