There are so many things to do lately, but so little time. Plus i have so many dental problems lately, three of my molar teeth has been pulled out in the last 2 months, and going to have the fourth taken next month. Going to dentist and waiting for the recovery always takes away my free time.
My wife just bought Nokia 5800, a Nokia series 60 5th edition phone. It means that i need to finish my SymbianBible port for 5th edition (mostly done, beta version is on symbianbible google groups). My wife also asked me to port MultiCounter to her new phone (done, not yet uploaded).
I have cleaned up the 2.6.29 port of STR9104 Soc, but i will need to clean up again, because of the new documentation from www.cnusers.org. I have also started the freebsd port, but the progress is not much yet.
When the NSD Emprex 100 arrived, i realized that I need more network ports. I only have 4 ports on my WRT54GL and all of them have been used. After looking at hubs and routes prices around chiang mai, they are in 500-1000 baht range, that is not cheap so I decided that I should just buy something a little bit more expensive that I can hack. I saw DLink DIR-300 sold at relatively cheap price 1490 baht (43 usd, cheap for Chiang Mai price), this is 700 baht (20 usd) cheaper compared to WRT54GL, with almost same hardware spec (4 Mb ROM, 16 Mb RAM). I spent some time installing openwrt on this router, because I was so confused with the factory built interface.
I am planning to go to Indonesia for 10 days, so during that time, I don’t think I will be able to do much hacking, but I want to still continue studying freebsd. So I decided to install FreeBSD on our EEE PC 901. This was not difficult, but it took quite some time to setup everything.
Here are some of the things that i’ve done on the EEE PC: setup FreeBSD ARM cross compile, setup Linux ARM cross compilation, setup LXR for FreeBSD current sources. Unfortunately WIFI is still not supported on EEE 901, and all (I only have 2) of my USB bluetooth doesnt work.
Note: I haven’t made tha 64 Mb Linux Kernel Image. I was affraid that someone made a mistake flashing it to 32 Mb device, which will made it unusable. Of course serial port can still save it, but not every one can make a serial port. With the new documentation I found, I will be able to make kernel image that can autodetect the memory size.